18 Watt 24V DC | T8 LED Tube Light | 4 foot
Our 4 ft 24V DC LED tubes replace your T8, T9, T10 or T12 fluorescent 34 to 40 watt tube lights, (they all use the same pin sockets but the diameter of the tube is different). Our LED tubes will use half the power of a fluorescent tube, and last 2 to 3 times as long! Unlike fluorescents, this tube uses LEDs, contains no mercury, and has unlimited ON-OFF cycles. Best of all, it turns on almost immediately and gives full brightness, even in cold temperatures. The soft daylight colour is great for most areas of your house or office, and is excellent for reading. They also require no ballast, so that nasty hum is eliminated. Simply remove your old ballast and connect power directly to the pin sockets.These tubes also have rotatable ends and you can then direct the light where you want it.
Voltage: 24V DC
Diameter: 1 inch (26 mm) Don't worry, if your conventional 4 ft fluorescent tube is 1 1/2 inch in diameter, the end pins will still fit!
Length including pins: 47 3/4 (121 cm) (Nominal 4 ft tube)
Lifespan: 30,000 hours at ambient temperature, longer life at cooler temperatures.
Ambient Temp: -20F to 120F (-30C to 50C).
No radio frequency interference
No ballast required, Power Factor only 0.92-0.94
Great amount of light. Easy to install. Get interference on radios.